Do you know the reason for the high power consumption of electric boilers? Follow the editor of Electric Boilers for Hydronic Heating to have a simple understanding!
1. The house insulation effect is not good
If the room where electric boilers are installed is not well insulated, it will lead to temperature loss. If you want to reach the temperature you want, you should adjust a higher temperature. In this way, you can make up for the lost temperature, which will waste more electricity. .
2. The height of the room is high
When the height of the room is higher, the area of heat sharing will be larger and larger, so if you want to achieve a higher indoor temperature, you should increase the higher indoor temperature.
3. Frequent opening and closing of doors and windows
Frequent opening and closing of doors and windows easily affects the indoor temperature, causing the indoor temperature to drop, and the room is constantly heating up, so the power consumption is high.
4. The power of the electric boilers installed in the room is incorrect
The installed power of electric boilers is generally 100W per square meter. According to the use environment, if the ratio is too large or too small, power resources will be wasted.
5. Caused by unreasonable geothermal laying
When the geothermal is laid, the insulation layer under the geothermal pipe is too thin, less than 3 cm, and the leveling layer and floor tiles above the geothermal pipe are too thick, exceeding 5 cm. The heat cannot be conducted upwards well, and all is wasted from below.
6. The geothermal surface is covered with the floor
After the geothermal heat was laid, another floor was laid. The floor was cool and insulated, and the heat below could not come up, and the power consumption increased.
The above is an introduction from the editor of Electric Boilers for Hydronic Heating: an introduction to the reasons for the large power consumption of electric boilers.
Are Electric Central Heating Boilers Expensive to Run?
